Then the air passes through the filter and back into the room.. Bagless or Bagged?.
or the floor tool.. Start by checking either ends of the hose to see if there is an obvious blockage.You may be able to pull out the blockage using your hand or a non-sharp tool (be careful not to damage the hose.).
If you can’t see a visible blockage, squeeze along the hose to try and find it.Once you’ve located the blockage, try bending and squeezing the hose around this area.Reattach the hose and turn on the vacuum to see if the blockage has been loosened enough to be sucked into the vacuum..
If there’s no blockage in the hose, take apart the floor tool by removing the pin.Check for any blockages.. Why Has my Henry’s Power Cut Out During a Long Cleaning Session?.
Modern Henry vacuums have a. cut-out system to prevent the motor from overheating.
If your vacuum has stopped working after being on for a long time, then this is likely to be the issue..Others have a cup shape, so you’ll need to fill the filter with cold water, give it a small shake, tip out the dirty water, then repeat.
Remove excess water.Some Dyson filters can be gently wrung out to remove excess water, while others should just be tapped off into a sink.
Check the manual before wringing out a filter, as using this method can damage certain types of filter..Allow the filter 24 hours to dry.